top of page


Public·5 members

Driver Sigmatel High Definition Audio Codec

My Dell XPS M1330 laptop uses an audio device referred to as the Sigma Tel High Definition Audio CODEC. Unfortunately after installing a fresh copy of Windows 7 64 bit no audio could be heard, even though the volume was up at full and all the device drivers reported did not any problems.

Driver Sigmatel High Definition Audio Codec

The Service Pack 3 update to Windows XP and all later versions of Windows included the Universal Audio Architecture (UAA) class driver, which supported audio devices built to HD Audio's specifications. Retrospective UAA drivers were also built for Windows 2000, Server 2003 and XP Service Pack 1/2.[3] macOS provides support for Intel HD Audio with its AppleHDA driver. Several Linux operating systems also support HD Audio, as well as OpenSolaris,[4] FreeBSD,[5] and OpenBSD.[6]

Like AC'97, HD Audio acts as a device driver, defining the architecture, link frame format, and programming interfaces used in the hardware of the host controller of the PCI bus and linking it to a codec used by a computer's software.[7] Configurations of the host controller (Chipset) are available from third-party suppliers, including Nvidia, VIA and AMD,[7] while codecs have also been provided by third-party suppliers including Realtek, Conexant, IDT, VIA, SigmaTel, Analog Devices and Cirrus Logic.[8][9] AMD's TRX40 chipset was introduced in 2019 for use with Ryzen "Threadripper" CPUs, which provided the Realtek ALC1220 chip instead of the HD Audio interface. As a result, a separate USB or PCIe audio device was required to integrate HD audio codecs on TRX40 motherboards.[10]

Here another solution from =1285346&siteid=17copperminecottage I believe I have a solution. Scenario: I bought a new Sony Vaio on Sunday, and upgraded Vista to Vista Ultimate yesterday. Immediately the sound system fell silent. After following other suggestions I checked the updates I had installed following the upgrade to Ultimate. Windows and discovered that Update for Windows Vista (KB929685) says:"Install this update to address an issue that may prevent high-definition audio devices from initializing after resuming the system from a sleep or hibernation state."I had put the PC to sleep around that point.Here is what I did next:In Conrol Panel -> System -> Select the Device Manager and find the Sound entry. Expand it. Click the entry for High Definiton Audio Device with the right mouse button. Uninstall it and the software too (check the box).Now put the PC to sleep. When it restarts it will reinstall the Audio device. Meantime the update above (KB929685) seemed to have kicked in and PRESTO - sound again!Worked for me. Good luck.

A problem which I've found is regarding audio, the sound is not as clear as it was in Windows 8.1. Microsoft automatically downloaded and installed "High Definition Audio Device" as the default driver for audio. A screenshot of my Device manager showing the default audio driver is attached for reference.

From the official HP drivers download page for Windows 8.1 (64-bit), I noticed the Driver-Audio as "IDT High-Definition (HD) Audio Driver version: 6.10.6491.0 Rev." I am missing out on this driver for my audio in Windows 10 but the version stated was for Windows 8.1 (64-bit).

The only drivers available for your system are those on the driver download page. If there are no audio drivers for Windows 10, HP does not have an enhanced audio driver for Windows 10 for your system. Those devices that are getting full feature Windows 10 drivers will have got them by now. One of the costs of upgrading operating system can be accepting that some devices get basic feature drivers.

But v1803 stopped that from working. With the W8.1 driver from my notebook's support page, I had no audio at all, and had to rely on the terrible generic HD audio device Windows 10 v1803 installed. Plus the volume was much lower. 350c69d7ab


Welcome to the group! You can connect with other members, ge...

Group Page: Groups_SingleGroup
bottom of page